![]() ![]() Start with 9600 and if that seems to be too slow, bump it up to 19200 or even higher - if the rig can go higher. You can choose whatever baud rate you like. ![]() they don't use the Serial port to upload) so you can get away with, for example a Teensy2 which has one Serial port and use that for the CI-V bus. If you have a Teensy, it is even easier because Teensys use native USB to upload code (i.e. ![]() You can then have program uploading done on the Serial port as usual, and have the CI-V bus connected to Serial1. It's much easier if you have an Arduino which has at least two hardware serial ports. You could use the Arduino's hardware Serial port on pins 0 and 1 but that makes development/debugging difficult. When you use softwareserial you can't read a character while you are writing one. Rewritten URLs on this mirrored page may not work.The CI-V protocol requires that you be able to read and write a serial character at the same time because CI-V requires that when you write a byte, you also read it back to make sure it is what you sent (the CI-V hardware "reflects" the Tx back into the Rx). ⚠️ Content here is for search engine crawlers. 01 for OnĪbout GitHub Wiki SEE, a crawler enabler for GitHub Wikis as GitHub blocks
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |